An Incredible Way to Reduce Body Fat Without Going Under the Knife
Perhaps the most troublesome issue to many people in the 21st century is how to reduce body fat with lifestyle conditions like obesity increasingly affecting large sections of the population, even in developing countries. Suppose dieting, exercise, and invasive techniques of reducing body fat are not working for you. Then, you need to go for a laser technology known as TruSculpt 3D in New York performed by a specialist, Norman J. Pastorek, MD, PC, FACS.
Meet Norman J. Pastorek, MD, PC, FACS
Dr. Pastorek is indisputably one of the best and most experienced international facial plastic surgeons, based in his practice at Upper East Side, New York. Having performed facial plastic surgery for over 30 years, Dr. Pastorek has immense knowledge that patients can rely on.
Some of the procedures performed by Dr. Pastorek in his practice in NYC include:
- Chin augmentation
- Brow lifts
- Skin rejuvenation using Botox, platelet-rich plasma (PRP), laser skin treatments and injectable fillers.
The Best Doctors in America, U. S. News, World Reports Top Doctors, and Castle Conelly’s Top Doctors are just some of the magazines to recognize Dr. Pastorek’s outstanding work. Dr. Pastorek has performed over 7000 rhinoplasties, 3000 blepharoplasties, and 2700 facelifts.
When it comes to reducing body fat, Dr. Pastorek uses the latest laser technology, truSculpt 3D, which is minimally invasive and guarantees quick and long-lasting results.
What You Need to Know About TruSculpt 3D
Whether you have a tight schedule that does not allow you to exercise regularly or you find it challenging to stick to a diet to trim fat in your body, worry no more because Dr. Pastorek has the answer for you, TruSculpt 3D.
TruSculpt 3D is a cutting edge laser technology of removing fat where it is not wanted, e.g. excessive fat in the:
- Upper arms
Once the fat cells have been eliminated using TruSculpt 3D, they cannot grow again hence giving you the trimmed body look you wanted.
TruSculpt 3D: How it Works
TruSculpt 3D uses low frequency, high conductivity radio frequency to penetrate deep into the skin layers where the fat tissue is located. During the process of skin penetration by the radio frequencies, the optimum temperature of the skin is maintained.
The process starts when Dr. Pastorek moves a wand transmitting the radio frequencies around the target area of the body for 15-45 minutes. The radiofrequency destroys the fat cells and during the process, due to heat being discharged, you may experience slight discomfort; however, Dr. Pastorek will adjust the device for comfort.
After the radio frequencies have destroyed the fatty tissue structure, they are eliminated naturally by the body through the lymphatic system. Redness on the affected spots of the skin may be observed, but it usually resolves in a couple of days.
What You Should Do Before Going For TruSculpt 3D Procedure
Before going for the truSculpt 3D treatment, you should observe the following:
- Remove any piercings or jewelery on the targeted spots
- Avoid caffeinated drinks as they increase sensitivity to the heat
- The area should be void of body cream or lotion
The Results of Using TruSculpt 3D for Body Sculpting
Usually, the results of using truSculpt 3D in fat removal are seen in 3 weeks, or sometimes even months. Both men and women require approximately two to three sessions for maximum effect. Dr. Pastorek will also recommend that you try to observe your diet and exercise along with this type of treatment.
If you are seeking a noninvasive technique for removing excess body fat with lasting effects and little downtime, then you need to call Dr. Pastorek or book online!